Maytag’s MEDC465HW feature sheet describes Wrinkle Control as 40 minutes of additional no-heat tumbling after drying. Compare that normal post-cycle behavior with continuous running, continued heating or failure to advance through a timed cycle before deciding that the timer has failed.
Models covered
MEDC465HW model family, as identified by the manufacturer feature sheet. This does not establish every HW0 engineering revision or an internal timer part. It is an electric-dryer feature explanation.
Stop for smoke, burning smells, abnormal heat or repeated breaker trips. Let the dryer cool before cleaning. Do not expose wiring, bypass interlocks or work on gas components. If gas is smelled, leave and call the utility or emergency services from a safe location.
Compare the behavior
Match the documented control, cycle or feature before interpreting the result. The comparison below keeps normal model behavior separate from an unresolved fault.
| Observed state | Interpretation / next step |
|---|---|
| Drying ended + Wrinkle Control selected | Compare with the model’s 40-minute no-heat feature. |
| Still heating or failing to finish Timed Dry | Does not match a simple post-cycle explanation. |
| Normal stop control does not work | Stop use and obtain professional help. |
Model-specific checks
Record the setting and timing
Note whether the drying portion has ended and Wrinkle Control was selected. A post-cycle feature should not be mistaken for a cycle that never finishes drying.
Compare the documented behavior
The model’s sheet gives 40 minutes of no-heat tumbling. A different pattern, especially continuing heat or unbounded running, does not fit that simple explanation.
Review the normal stop controls
Use the actual panel and owner’s manual to end operation. Do not open panels, bypass a door switch or choose a timer part based on the symptom.
Escalate behavior outside the feature
If the machine fails to stop through normal controls, heats abnormally or keeps running beyond the documented behavior, stop using it and arrange service. Provide selected cycle, option and elapsed time.
What to record next
Compare the tumbling period with the duration in the MEDC465HW feature sheet. Intermittent tumbling during Wrinkle Control is different from a dryer that will not stop when the option is off or the door is opened.
When to stop and get help
Only carry out maintenance permitted in your model’s manual. For service, note the full model number and suffix, displayed code, selected cycle and what happened during the checks. Leave internal wiring, gas components, pumps and safety devices to a qualified professional. A symptom alone does not identify a failed part.
Sources & references
- Wrinkle Control adds 40 minutes of no-heat tumbling. Model specification sheet p1
- Maytag: MEDC465HW manufacturer specification sheet
- Maytag: MEDC465HW owner center
- Maytag: dryer turns on after cycle completion
Based on publicly available manuals, manufacturer support and the references listed here. We have not inspected or tested your appliance. Follow the instructions for your exact model; a guide cannot replace an in-person diagnosis.