Maytag dryers troubleshooting
Use the symptom or code to choose a safe starting point for Maytag dryers. Verify the exact model before maintenance.
Is it cold, slow, or stopping early?
No heat, warm-but-wet laundry and an early Sensor Dry ending are different starting points. Identify electric, gas or heat pump before using a supply checklist.
MEDC465HW keeps tumbling after the cycle ends
Maytag’s MEDC465HW feature sheet describes Wrinkle Control as 40 minutes of additional no-heat tumbling after drying.
Follow the checksMaytag Dryer L2 but the Drum Still Runs
Maytag says L2 can indicate low or missing supply voltage that prevents heating while the drum continues running.
Follow the checksMaytag Dryer AF After Cleaning: Check the Whole Exhaust Path
AF or Check Vent concerns restricted airflow.
Follow the checksMaytag Dryer PF After an Outage: Resume or Investigate?
PF indicates that a power failure interrupted drying.
Follow the checksMaytag Dryer F3 E2: Moisture Sensing, Not a Washer Code
For the dryer support page cited here, Maytag identifies F3 E2 with moisture sensing.
Follow the checksMEDB835DW Sensor Dry: Change the Saved Dryness Setting
MEDB835DW supports a saved Sensor Cycle dryness adjustment from standby.
Follow the checksMED7230HW Steam Refresh Leaves Wet Spots
Steam Refresh on MED7230HW is intended to refresh dry garments, not to dry a wet washer load.
Follow the checksMED6500MW Pet Pro Runs Without Heat: What Is Normal?
The MED6500MW Pet Pro option deliberately uses an extended no-heat period to lift hair into its XL lint trap.
Follow the checksMED6230HW Connects to the App but Will Not Start Remotely
Connecting MED6230HW to the app and authorizing remote control are separate steps.
Follow the checks